Seat Alhambra Key Problems

Seat's jumbo MPV family is among the top models in its class when it comes down to resale value. With a brand new model on sale, the jumbo family MPV is even better.

There are many reasons the key fob may not function properly, such as an inoperative coin battery damage to the receiver module, or signal interference. This article will walk you through the steps to get it working again.

Water Damage

If your key fob for the seat replacement key cost alhambra can withstand a wash cycle or dip in the ocean or a pool, then it's equipped with a waterproof chip. However, don't do it often since prolonged exposure to water can increase chances of the key fob getting damaged. If your key fob ceases to functioning after being exposed to rain or clean tap water, unplug the battery and wipe the electronic component using a towel. Let it dry completely before replacing the battery. If the key fob has been exposed to soapy or salty water, it is recommended that you clean the chip using isopropyl or electronic cleaner.

Faulty Receiver Module

If the key fob does not lock or unlock after having replaced the battery of the button it could be that the receiver module has a fault. The good news is that this is an easy and affordable fix, you can disconnect the 12 volt battery for just a few minutes (first take off the negative cable then press the horn button multiple times) to remove any remaining electricity and then reconnect it in reverse order e.g. positive cable first and then negative cable later.

ESP Warning Light - If the ESP warning symbol flashes this is normal and means that the car is traveling on terrains where the traction between the road surface and tyres isn't optimal, such as gravel, snow or a lot of surface water. If the ESP light is always on, it indicates that there is a fault in the system. This can be identified with a iCarsoft i908 seat car key OBD code reader kit. It will give you a detailed fault description.

Dead Coin Battery

A dead battery for the coin is among the most frequent reasons for the seat alhambra keys to cease to function. The key fob is powered by an insignificant button cell battery which keeps it powered. Replace it with a brand new battery with the same dimensions, voltage and specs as the original. If you are replacing the battery, ensure that you remove all metal clips from the back of the key fob. You should also make sure that the contacts are clean and free of corrosion.

If the key fob has been exposed water, such as soapy or rain it is recommended to remove the battery and clean the electronic chip using isopropyl alcohol or a electronic cleaner prior to installing the new battery. The chip is sensitive to moisture and may be permanently damaged. If the key fob still not working after replacing the battery, it may be necessary to replace the entire key fob.

Faulty Receiver Module

If your key fob stopped working after replacing the battery but it didn't help, or it stopped working completely suddenly the receiver module might have developed a fault. The receiver module receives radio frequency signals from your remote keyfob and transforms them into electrical signals which are then used by other modules in the car.

If the receiver module has developed a fault that prevents it from responding to any of the commands issued by your remote key fob. In this instance you will require a dealer to reprogramme your key fob, and also install the new receiver.

The key fob is encased by rubber to block water from leaking into the electronic chip. If you dip the key fob into salted or soapy water it may damage the chips. If your key fob won't work, you can try cleaning the chip with isopropyl or an electronic cleaner.

If the keys are paired, but the receiver module is faulty, you can try to restart all the electronics in the board by disconnecting the battery with 12 volts for a few minutes. Connect the battery in reverse (negative cable to positive first). This will reset the on-board electronic and restore their functionality.

Faulty Electronic Chip

The key fob is equipped with a tiny chip which transmits an indication from the key to the receiver module each time the key is used. If this signal does not match the one recorded by the car the immobilizer will shut down the engine and prevent the vehicle from beginning. If the key fob you purchased does not work and you are unable to reprogram it, this could be due to a malfunctioning microchip.

The chip inside the key fob may have change in order to make it function properly. This can be done by taking the key fob away from its case, and using pins or needles to contact each metal retaining clip. You'll have to replace them in the event of damage or damaged by corrosion. Make sure that the replacement batteries are of the same voltage, size, and specification as the original.

Seat Alhambra, a renowned and well-designed model, may have problems with certain components or equipment. Some owners have reported problems with the auto climate control system. It is prone to fail and cause problems, and then get stuck in a certain setting. The infotainment system has also been reported to malfunction and freeze screens.